how to use virtual audio cable to record system sounds

HOW TO USE VIRTUAL AUDIO CABLE TO RECORD SYSTEM SOUNDS HOW TO

If you're certain your application is recording properly, but isn't displayed here, try changing the dropdown box in the bottom right of PulseAudio Volume Control from 'Applications' to 'All Streams'. Now switch over to PulseAudio volume control, and on the 2nd tab labeled 'Recording', you should see your application recording, and if it's picking anything up you may see a bar jumping. By default it will probably start capturing from your microphone, which is why this just a test run. Open the software you wish to record the audio with, and start recording. We now have to do a test-run before we can begin using it.

It should be listed in your applications menu as ' PulseAudio Volume Control'. Once you have it installed, you can now use it to re-direct your audio. You can also click on this apt link to do so: apt://pavucontrol Open Synaptic, or the Ubuntu Software Center, and search for and install the Pulse Audio Volume Control program called 'pavucontrol'.

HOW TO USE VIRTUAL AUDIO CABLE TO RECORD SYSTEM SOUNDS HOW TO

If you are using an older version of Ubuntu (7.10 and earlier), then you can see how to set up pulseaudio at this wiki page: In newer versions of Ubuntu, this is already taken care of by default. The first pre-requisite is that you have Pulseaudio installed. You can use this to record sound directly from your system without capturing any background noise that your microphone would pick up, and without losing nearly as much audio quality. It is possible in Ubuntu, and other Linux distributions that use pulseaudio, to redirect sound that is played to a virtual input device.

How to use virtual audio cable to record system sounds